The overall control block diagram of the three-phase L-filter grid-connected inverter is shown in Figure 1. Among them, eabc and iabc represent the three-phase grid voltage and grid current, Udc is the DC bus voltage, and Ldbc is the grid-side inductance., iαβ is the component of the three-phase grid side current in the two-phase static αβ coordinate system, id*, iq* are […]
Read More
In order to achieve lower harmonic distortion of grid-connected current, problems such as low-frequency harmonic distortion of grid-connected current must be solved. This article briefly analyzes the causes of low spectrum waves and introduces several current control methods for current suppression of low spectrum waves commonly used in L-filter solar grid tie inverter. Read more: Influence […]
Read More
The previous analysis only considers the influence of the artificially added dead time on the output voltage of the bridge arm and the incoming current of the bridge arm to prevent the bridge arm from passing through. However, the turn-on and turn-off of actual power devices is not instantaneous, and there is a turn-on voltage […]
Read More
1. The influence of low frequency harmonics of grid voltage The equivalent model of the grid-connected inverter is shown in Figure 1, in which the output voltage uinv of the bridge arm of the inverter is equivalent to a controlled voltage source (the specific form is related to the inverter control). Using the superposition theorem, […]
Read More
Overview of current control techniques for single L filter grid-tied inverters The current control block diagram of the single-L filter grid-connected inverter is shown in Figure 1. The inverter bridge is simply equivalent to a proportional link with a gain of kPWM, and kPWM is the ratio of the DC side voltage to the amplitude […]
Read More
